lehuy0305's Blog

Thông tin cá nhân

lehuy0305
Họ tên: Lê Thanh Huy
Nghề nghiệp: Developer PHP
Sinh nhật: 3 Tháng 5
Nơi ở: Hà Nội
Trạng thái: User is offline (Vắng mặt)
Thêm vào nhóm bạn bè
Gửi tin nhắn
Chào tất cả các bạn!************ ^_^ *********** !Dù Thế Nào Đi Nữa*******Anh vẫn mãi yêu em,Ngốc ạ!*************

Xem theo danh mục
Xem theo danh mục:
     


Tìm kiếm:
     



CHBTNSB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31

Tik Tik Tak ! ^_^..........?


   Trong: CCNA
 
31.


With VLSM, which bit mask should be used to most efficiently provide for the number of host addresses required on Router B?
/26
/27
/28
/29
/30
32.
Which group of commands allows a router to be administered remotely?
line con 0
password class
login
interface dialer 1
ip address 192.168.10.1 255.255.255.0
access-class 1 in
line vty 0 4
password cisco
login
interface vlan 1
ip address 192.168.10.1 255.255.255.0
no shutdown
33.
Which networking devices can be used at the access layer of the hierarchical network design model? (Choose two.)
AUI
hub
Layer 3 switch
ISDN hub
Layer 2 switch
Frame Relay switch
34.
What are the recommended HyperTerminal configuration settings for establishing a console session between a switch console port and PC COM port? (Choose three.)
Bits per second: 9600
Bits per second: 4800
Parity: None
Stop bits: None
Data bits: 8
35.


Refer to the graphic. What is the most popular trunk encapsulation protocol that could be configured on SW-A Port 0/1?
Spanning Tree
RIP v2
IEEE 802.1Q
ARP
36.


Refer to the graphic. Which of the following commands will configure router A for OSPF?
router ospf 1
network 192.168.10.0
router ospf 1
network 192.168.10.64 0.0.0.63 area 0
network 192.168.10.192 0.0.0.3 area 0
router ospf 1
network 192.168.10.64 255.255.255.192
network 192.168.10.192 255.255.255.252
router ospf 1
network 192.168.10.0 area 0
37.


Refer to the graphic. Two routers have been configured to use EIGRP. Packets are not being forwarded between the two routers. What could be the problem?
EIGRP does not support VLSM.
The routers were not configured to monitor neighbor adjacency changes.
The default bandwidth was used on the routers.
An incorrect IP address was configured on a router interface.
38.


Refer to the graphic. Router B does not need to send routing updates to Router A. Which command can be used by Router B to prevent RIP from sending these updates?
passive-interface fastethernet 0/0
passive-interface serial 0/0
access-class 12 out
access-class 12 in
39.
A company has 200 hosts that are assigned addresses from the 172.68.1.0/24 network. A planned expansion will result in an additional 400 hosts. What is the most technically effective and most cost effective way to provide the necessary host addresses for this expansion?
Arrange for a Class B registered address.
Share IP addresses between multiple hosts.
Use private IP addresses with PAT.
Use VLSM to more efficiently utilize the existing addresses.
Arrange for additional Class C registered addresses.
Restrict access using extended ACLs.
40.


R3 has the following configuration:

R3# show running-config
--some output text omitted--
interface serial0/0
bandwidth 128
ip address 192.168.11.2 255.255.255.0
encapsulation frame-relay
frame-relay map ip 192.168.11.2 30 broadcast

After the command R3# debug frame-relay packet is executed, a ping is issued from R3 to R1 but is unsuccessful. Based on the output of the debug command shown in the graphic and the router configuration, what might be problem?
No clock rate assigned.
There is an incorrect DLCI number in the map statement.
An incorrect IP address exists in the map statement.
The encapsulation command is missing the broadcast keyword
41.
Given the IP address and subnet mask of 172.16.134.56 255.255.255.224, on which subnetwork does this address reside?
172.0.0.0
172.16.134.0
172.16.134.32
172.16.134.48
172.16.134.47
172.16.134.63
42.
Given the IP address and subnet mask of 172.16.134.48 255.255.255.224, which of the following would describe this address?
This is a useable host address.
This is a broadcast address.
This is a network address.
This is not a valid address.
43.
Which of the following router connections is most often to be used to connect a LAN?
BRI
synchronous/asynchronous serial
console
Fast Ethernet
44.
Which of the following statements are correct when comparing the differences between PAP and CHAP? (Choose three.)
PAP sends passwords in clear text.
PAP uses a 3-way handshake to establish a link.
PAP uses the router to control the frequency of login attempts.
CHAP uses a 2-way handshake to establish a link.
CHAP encrypts the password while providing protection against playback attacks.
CHAP uses repeated challenges for verification.
45.


Refer to the graphic. Routers A and B have EIGRP configured and automatic summarization has been disabled on both routers. Which one of the following router commands is used to summarize the attached routes, and to which interface is this command applied? (Choose two.)
ip summary-address eigrp 1 192.168.10.64 255.255.255.192
ip area-range eigrp 1 192.168.10.80 255.255.255.224
summary-address 192.168.10.80 0.0.0.31
ip summary-address eigrp 1 192.168.10.64 0.0.0.63
serial interface on router A
serial interface on router B
46.
Which of the following IOS commands defines the "interesting traffic" that causes an ISDN link to become active, and which command assigns that definition to an interface?(Choose two.)
Router(config)#dialer 1 idle-timeout 180
Router(config)#dialer-list 1 protocol ip permit
Router(config)#dialer map ip 192.168.100.1 name sanjose 555 1234
Router(config-if)#dialer-group 1
Router(config-if)#dialer 1 string 555-5000
47.
When EIGRP is configured on a router, which table of DUAL information is used to calculate the best route to each destination router?
router table
topology table
DUAL table
CAM table
ARP table
48.


Refer to the graphic. Two VLANs have been configured on the switch and hosts have been assigned. Hosts in the Sales VLAN can ping all hosts in their own VLAN, but can not ping the hosts in the HR VLAN. Why is this true? (Choose two.)
All hosts are in one collision domain.
All hosts are in one broadcast domain.
A router is required for communication between VLANs.
The hosts are in separate broadcast domains.
The management VLAN has not been assigned an IP address.
49.
Which protocol utilizes features of both distance-vector and link-state routing?
RIP v1
RIP v2
EIGRP
OSPF
50.


An administrator who is consoled into the Peanut router is able to ping the Serial0 and Ethernet0 ports of the Popcorn router but unable to ping its Ethernet1 interface. Use the graphic and command output to identify possible causes for this problem. (Choose two.)
The Serial interface of the Popcorn router is shutdown.
The Ethernet1 interface of the Popcorn router is shutdown.
The Popcorn router did not include network 192.168.12.0 in its routing configuration.
The Popcorn router is not forwarding RIP updates.
The clockrate is missing from the configuration of one of the routers.
51.
What is the purpose of the passive-interface command?
allows a routing protocol to forward updates out an interface that is missing its IP address
allows a router to send routing updates on an interface but not receive updates via that innterface
allows an interface to remain up without receiving keepalives
allows interfaces to share IP addresses
allows a router to receive routing updates on an interface but not send updates via that interface
52.
Which of the following options can be negotiated using LCP during the PPP link establishment? (Choose three.)
callback
IPCP
CHAP
multilink
TCP
Q.931
53.

Refer to the graphic. A named access list called chemistry_block has been written to prevent users on the chemistry network and public Internet from access to the records server. All other users within the school should have access to this server. The list contains the following statements:

deny 172.16.102.0 0.0.0.255 172.16.104.252 0.0.0.0
permit 172.16.0.0 0.0.255.255 172.16.104.252 0.0.0.0


Which of the following command sequences will place this list to meet these requirements?
Hera(config)# interface e0
Hera(config-if)# ip access-group chemistry_block in
Hera(config)# interface s0
Hera(config-if)# ip access-group chemistry_block out
Apollo(config)# interface s0
Apollo(config-if)# ip access-group chemistry_block out
Apollo(config)# interface s1
Apollo(config-if)# ip access-group chemistry_block in
Athena(config)# interface s1
Athena(config-if)# ip access-group chemistry_block in
Athena(config)# interface e0
Athena(config-if)# ip access-group chemistry_block out
54.
Which statements are true regarding the command sequence shown below? (Choose three.)

RouterA(config)#interface loopback 0
RouterA(config-if)# ip address 192.168.31.33 255.255.255.255
It creates a virtual, software only, interface.
It uses a wildcard mask of 255.255.255.255.
It ensures than an interface is always active for OSPF processes.
It provides a way to test the convergence of OSPF routing updates.
The mask of 255.255.255.255 is called a host mask.
These commands can only be issued to configure serial interfaces.

 

> Trả lời nhanh
Bình luận của bạn sẽ được đăng sau khi chủ blog kiểm duyệt và chấp nhận
Nhập vào tên của bạn:
Nhập mã số xác nhận (bắt buộc):
» Hiển thị cửa sổ mặt cười       » Download bộ gõ tiếng Việt Unikey
 Bạn có muốn chuyển các ký hiệu như :) :( :D ...thành mặt cười trong bài viết này?
 Bạn có muốn chèn thêm chữ ký vào bài viết này ?
 


 
Lượt xem thứ:





Mạng xã hội của người Việt Nam.
VnVista I-Shine © 2005 - 2024 VnVista.com