lehuy0305's Blog

Thông tin cá nhân

lehuy0305
Họ tên: Lê Thanh Huy
Nghề nghiệp: Developer PHP
Sinh nhật: 3 Tháng 5
Nơi ở: Hà Nội
Trạng thái: User is offline (Vắng mặt)
Thêm vào nhóm bạn bè
Gửi tin nhắn
Chào tất cả các bạn!************ ^_^ *********** !Dù Thế Nào Đi Nữa*******Anh vẫn mãi yêu em,Ngốc ạ!*************

Xem theo danh mục
Xem theo danh mục:
     


Tìm kiếm:
     



CHBTNSB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30

Tik Tik Tak ! ^_^..........?


   Trong: CCNA
 
1.
A company needs to extend the LAN to six separate buildings. To limit the amount of signal attenuation on the LAN media, what type of media would be the best to use between the buildings?
air (wireless)
coaxial cable
fiber
shielded twisted pair
unshielded twisted pair
2.
A small company is experiencing difficulties on its LAN. After performing some tests, a technician has determined that the copper media supporting the LAN is experiencing abnormal attenuation. What are two possible causes of the problem? (Choose two.)
defective connectors
excessively long cable lengths
use of higher grade cabling
low frequency signals used in the media
network cable runs isolated from other cables
3.
What is a cause of crosstalk in UTP cable?
cable pairs that are shorted
cable pairs crossed during termination
cabling runs installed in separate conduit
cable pairs that are untwisted because of poor termination of the cable
4.

Which of the following describes frequency?
length of each wave
height of each wave
number of cycles each second
amount of time between each wave
5.
How are binary ones and zeros represented in fiber optic installations? (Choose two.)
+5 volts/-5 volts
0 volts/5 volts
light/no light
high to low electrical transition
low to high electrical transition
increasing/decreasing light intensity
6.
What factors need to be considered to limit the amount of signal attenuation in Ethernet cable runs? (Choose two.)
type of users
number of users
length of cable
type of electrical equipment
installation of connectors on the cable
7.
Which of the following are detected by the wire map test? (Choose three.)
near-end crosstalk (NEXT)
opens
propagation delay
return loss
reversed-pair faults
short circuits
8.
To ensure reliable LAN communications, what should a technician be looking for when attaching connectors to the ends of UTP cable?
that the white-orange/orange pair is attached first
that the wire pairs remain twisted as much as possible
that one end of the shield is properly ground but not the other
that 50 ohm termination resistors are on both ends
9.
What conditions are described when transmission signals from one wire pair affects another wire pair? (Choose two.)
noise
resistance mismatch
jitter
crosstalk
attenuation
10.

What is expected when crosstalk is present in networks with higher transmission frequencies? (Choose two.)
jitter
increase in crosstalk
higher signal attenuation
increases in cancellation effect
destruction of more of the data signal

 

> Trả lời nhanh
Bình luận của bạn sẽ được đăng sau khi chủ blog kiểm duyệt và chấp nhận
Nhập vào tên của bạn:
Nhập mã số xác nhận (bắt buộc):
» Hiển thị cửa sổ mặt cười       » Download bộ gõ tiếng Việt Unikey
 Bạn có muốn chuyển các ký hiệu như :) :( :D ...thành mặt cười trong bài viết này?
 Bạn có muốn chèn thêm chữ ký vào bài viết này ?
 


 
Lượt xem thứ:





Mạng xã hội của người Việt Nam.
VnVista I-Shine © 2005 - 2025 VnVista.com